OVERVIEW
Farrprene IF800A is a firm, hard-wearing compound for structural flexible parts, seals and bushings. Supplied as a natural filled grade optimised for injection-moulding, it pairs the soft-touch feel of rubber with the clean, fast processing of a thermoplastic - no curing, fully re-meltable scrap.
The grade delivers a tensile strength of 6.0 MPa, elongation at break of >650%, and a specific gravity of 1.09. Its high melt flow (MFI 21 g/10 min at 190°C) fills thin-wall and complex injection geometries with short cycle times. SBS Based · Heat Stabilized.
TECHNICAL PROPERTIES
- HARDNESS
- 80 Shore A
- TENSILE STRENGTH
- 6.0 MPa
- ELONGATION AT BREAK
- >650%
- SPECIFIC GRAVITY
- 1.09
- MFI (230°C / 2.16 KG)
- 43 g/10 min
- MFI (190°C / 5 KG)
- 21 g/10 min
- APPEARANCE
- Natural
Typical average values from a limited sample set; not a formal specification. Request the signed datasheet for current values.
TYPICAL APPLICATIONS
- Structural flexible parts and snap-fit components
- Hard-wearing seals, bushings and grommets
- Profiles and trim requiring shape retention
- Construction profiles, gaskets and weatherstripping
- Consumer products, soft-touch overmoulds and grips
PROCESSING
- Runs on standard injection-moulding equipment; pre-drying is generally not required for unfilled grades.
- Filled formulation tuned for cost-efficiency and dimensional stability.
- Colour-matchable and re-processable - production scrap can be re-melted and reused.